Augmentation of Pyriform Margin Using Porous High-Density Polyethylene Sheet In Unilateral Cleft Lip Nasal Deformity.

Han, Ki Hwan; Kim, Jin Han; Choi, Tae Hyun; Kim, Jun Hyung; Son, Dae Gu

Search: J Korean Soc Plast Reconstr Surg Search

CLOSE

Original Article

Journal of the Korean Society of Plastic and Reconstructive Surgeons 2008;35(4):431-438.
Published online July 1, 2008.

Augmentation of Pyriform Margin Using Porous High-Density Polyethylene Sheet In Unilateral Cleft Lip Nasal Deformity.

Ki Hwan Han, Jin Han Kim, Tae Hyun Choi, Jun Hyung Kim, Dae Gu Son

Deparment of Plasic and Reconstructive Surgery, Keimyung University School of Medicine, Daegu, Korea. khh@dsmc.or.kr

Abstract

PURPOSE
The common deformity after the correction of unilateral cleft lip nasal deformity is nasal asymmetry, and it is caused by the hypoplasia of the pyriform aperture. To correct this, many procedures have been applied, but still many problems are present. Authors performed the inlay and onlay insertion of porous high density polyethylene sheet(1mm thickness Medpor(R) sheet) in the hypoplastic pyriform margin of cleft side and obtained satisfactory results. METHODS: 11 cases were performed and the mean follow up period was 15.1 months. Their mean age was 23.6 years. Under general anesthesia, bilateral pyriform margin was exposed. Medpor(R) sheets in "match stick" like shaped were inlay inserted, and kidney shaped were onlay inserted fixating with two 6mm titanium screws. After the surgery, the results was evaluated by photogrammetric analysis. On the basal view, the distance from the subalare and labiale superius' to the transverse baseline connecting the both cheilions was measured from the cleft side and the non-cleft side. Then, the postoperative symmetry was assessed by obtaining the cleft side against the non-cleft side as proportion index, defined as lateral and medial upper lip contour index.
RESULTS
There were 2 infections. The cause was because the inserted implant was too long and thus protruded to the base of nasal cavity. The lateral upper lip contour index was from 95.49 to 103.27, and medial upper lip contour index was from 90.92 to 100.49, it was statistically increased, and thus the symmetry was improved. However clinically mild depression remained at nostril floor.
CONCLUSION
Authors performed porous high density polyethylene sheet inlay and onlay insertion for the hypoplasia of the pyriform margin in unilateral cleft lip nasal deformity. It was found that depressed pyriform margin and upper lip were corrected effectively except for the nostril floor, for which an additional soft tissue augmentation would be necessary. The inlay insertion has risk of protrusion, thus the guideline of the use of artificial prosthesis should be observed strictly.

Keywords: Porous high-density polyethylene; Cleft lip nasal deformity; Pyriform margin augmentation

TOOLS