Erratum: Clinical Application of Three-Dimensional Printing Technology in Craniofacial Plastic Surgery

Article information

Arch Plast Surg. 2015;42(4):513-513

Publication date (electronic) : 2015 July 14

doi : https://doi.org/10.5999/aps.2015.42.4.513

¹Department of Plastic Surgery, Asan Medical Center, Ulsan University College of Medicine, Seoul, Korea.

²Department of Convergence Medicine, Asan Medical Center, Ulsan University College of Medicine, Seoul, Korea.

Arch Plast Surg 2015;42:267-77. http://dx.doi.org/10.5999/aps.2015.42.3.267

This erratum is being published to correct the printing errors on page 267. The last sentence of the Abstract contained a typographical error. The number '500' should have been '800'.

Before correction

"In addition, the benefits and possibilities of the clinical application of 3D printing in craniofacial surgery are reviewed, based on personal experiences with more than 500 craniofacial cases conducted using 3D printing tactile prototype models."

After correction

"In addition, the benefits and possibilities of the clinical application of 3D printing in craniofacial surgery are reviewed, based on personal experiences with more than 800 craniofacial cases conducted using 3D printing tactile prototype models."

Article information Continued

(open-access, http://creativecommons.org/licenses/by-nc/3.0/) :

This is an Open Access article distributed under the terms of the Creative Commons Attribution Non-Commercial License (http://creativecommons.org/licenses/by-nc/3.0/), which permits unrestricted non-commercial use, distribution, and reproduction in any medium, provided the original work is properly cited.